The laboratory ultrapure water machine pipeline has the function of transporting water source and connecting the filter element, which has a direct impact on the output. After the equipment is used for a long time, the pipeline needs to be cleaned, otherwise it will cause blockage. Let me talk about the cleaning steps:
1. The first cleaning: Install the used microporous filter rod in the stainless steel filter cartridge before the formal cleaning, and then replace the new microporous filter rod when it is put into use. Note that the hydrogen peroxide solution and the resin tank are prohibited during the cleaning process. contact.
2. The second and third cleaning: Use hydrogen peroxide solution to clean the pipeline repeatedly for half an hour. After cleaning, close the main pipe valve and let the hydrogen peroxide solution soak the pipeline for one hour.
3. The fourth cleaning: Use the method of flushing while draining water, and ensure that the flushing time is more than eight hours.
If you want to clean the dirt and bacteria on the inner wall of the laboratory ultrapure water machine pipe, you need to pay attention to the following aspects:
1. The hydrogen peroxide solution has strong oxidizing and bleaching properties, and is irritating to the human body. Therefore, it is recommended to wear rubber gloves and avoid direct contact during the cleaning process.
2. When the equipment is brand new, the editor recommends that the pipes should be fully cleaned before installing the membrane elements.
Through the above introduction, I believe everyone also knows the importance of regular cleaning. Regular scientific and effective cleaning of the laboratory ultrapure water machine pipeline can ensure the stable performance of the equipment and the quality of the produced water.
